Kip 7170K Bedienungsanleitung PDF herunterladen (Seite 23)

Chapter 1 Before Use 1-16

Pre-printed

Extremely slippery

Extremely sticky

Extremely thin and soft

OHP Film

1. 7. 2 Keeping the paper in the custody

Keep the paper in the custody taking care of the following matters.

1. Do not expose the paper to the direct sunlight.

2. Keep the paper away from high humidity. (It must be less than 70%)

3. Put the paper on a flat place

4. If you will keep the paper in the custody, which you have already unpacked, put it into the

polyethylene bag to avoid the humidity.

CAUTION

Do not use the paper with staple, or do not use such conductive paper as aluminium foil and

carbon paper.

The above may result in a danger of fire

NOTE

(1) Print image may become light if printed on a rough surface of the paper.

(2) Print image may become defective if the print paper has an excess curl.

(3) It will become a cause for paper mis-feed, defective print image or paper creasing if you

use a paper that does not satisfy the specification.

(4) Do not use a paper of which surface is very special, such as thermal paper, art paper,

aluminium foil, carbon paper and conductive paper.

(5) Do not use papers with unpacked (exposed in high / low temperature & humidity) in a

long period. Such papers may result in mis-feed, defective image or paper creasing.

(6) Tracing paper exposed to air over a long period tends to cause a defective printing.

Removing one round on the surface of the tracing roll paper from the beginning is

recommended.

Refer to [2.3 Replacing Roll Media].

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 74 75

Keine Kommentare

Kip 7170K Bedienungsanleitung Seite 23